In general, When you connect to PC with radxa( in loader mode), the PC can recongize radxa as Rockusb Device(windows)Ģ) the used usb port of pc is usb3.0 (please change usb2.0 port)ģ) the OS of PC is windows 8 (if windows 8,please use )Ĥ) bad quality usb cable, you can change a short and good quality one to try again This often happened by the follow reasons:ġ) Not enter the loader mode (refer to ) Troubleshooting FlashTool can not recognize the board Note: if your address of the partitions doesn't the same as the pic below, you can modify the address by click the address item. Then select the partitions you need update, and select the right image which you can find under rockdev or kernel directory. Or “Found One Loader Device” at the bottom of the tool when you flashed image not first time.
For information on how to make nand image see update.imgĪfter that, Click "Upgrade " to begin flashing Then Select an image (rockdev/update.img). Or “Found One Loader Device” at the bottom of the tool when you flashed image not first time You can see “Found One MASKROM device “ at the bottom of the tool when you first flash the board or just unbrick the board Power down the Radxa Rock board and connect the Radxa Rock board to the computer then let the board go to loader mode after the program should detect the device.
Now the driver is installed successfully.ĭownload the tool first AndroidTool_Release_v2.71.zip When the driver is installed successful you will then see a Rockusb Device in the device manager window. Select "Browse the computer for driver software".įind the file unzipped file you downloaded earlier (usb_driver_v3.5.zip) and select either the 32/64bit folder then click "OK" to install. Select the Unknown device then right click and select "Update Driver Software". After your computer should detect the board and you will see an unknown device within device manager. shut down the Radxa Rock board then connect the Radxa Rock board to the computer and let the board go to loader mode. For Win8 Download the file(usb_driver_v3.7.zip) from here. For WinXp,Vista,Win7,Download the file (usb_driver_v3.5.zip) from here. Now the driver should have been installed successfully!ĭownload driver file first. Then click “Install Driver” and when the driver has finish installing then shut down radxa board and connect the Radxa Rock board to your computer and let the board go to loader mode, then your computer will detect the board and you will see it within device manager.
If you've previously tried to install the Rockchip USB drivers for any Rockchip devices make sure you click “Uninstall Driver” first. Then double click on DriverInstall.exe in the RKDriverAssistant directory to start the utility. There’s no need to connect your Rockchip device during this procedure just download and extract RKDriverAssistant.zip Note:The method just support WinXp,Vista,Win7, NOT SUPPORT Win8 If you have already installed the USB driver please skip this step.